Table of Contents. Previous Page. Next Page. Page 6 According to the AAP , these infants may suffer breathing issues if improperly reclined in a car seat. Use the corrected age for preemies. Graco advises that you have your physician or hospital staff evaluate your infant and recommend the proper car seat or car bed Attn: Customer Service P.
Box , Elverson, PA or call or register online at www. Page 9 For future reference or if you change addresses, record the model name, model number, date of manufacture, and purchase date of this car seat below. You can find this information either on the registration card if you still have it or on the date label located on the back of the car seat. Page 10 Look for date of manufacture label on back of the car seat.
We also advise against purchasing a car seat second hand. Page 11 1-C Safety Warnings No car seat can guarantee protection from injury in every situation, but proper use helps reduce the risk of serious injury or death. Page 12 In a crash, an unsecured car seat can injure passengers. Visit www. Page 13 DO NOT use accessories or parts other than those provided by Graco except for a thin towel or mat to protect your vehicle seat or rolled towels or pool noodles to help get your car seat level.
Their use could alter the performance of the car seat. Page 19 2-D Adjusting Carry Handle 1. To Rotate Handle Press the handle adjustment buttons on both sides of handle. Handle Has 4 Positions Rotate handle to any of the 4 locked positions. Squeeze the base recline lever and lower the base to retract the foot. Check the level indicator for appropriate install. Use corrected age for preemies. Review section 6 for additional information.
Some vehicles have specific requirements for where the car seat can be installed. According to accident statistics, the safest place for your child in any vehicle is the back seat. Both systems are equally safe to use. Page 25 Graco convertible and all-in-one car seats have higher rear-facing limits that will allow children Vehicle Lap Only Seat Belt Page 27 3. Extend the Lower Anchor Attachment Strap Extend the Lower anchor attachment strap to its maximum length by pressing the gray button and pulling on the strap.
Page 28 5. To recline, review section 2-E. Page 29 7. Tighten the Lower Anchor Attachment Strap Press down firmly in the center of the base while tightening the Lower anchor attachment strap. Test For Tightness Grab the sides of the base where the Lower anchor attachment strap is and push and pull the base from side to side and front to Page 30 9.
Attach Car Seat to Base Place car seat into the base. Metal and plastic parts may be cleaned with mild soap and water. Buckle may be cleaned with a damp cloth. Place the buckle in a cup of warm water upside down and gently agitate the buckle, pressing the red button several times while it is in the water. Do not submerge the harness webbing and do not use soaps or lubricants, only rinse the harness buckle with warm water. Shake out the excess water and allow the harness buckle to air dry.
The LATCH system allows you to securely attach your car seat in your car without using the vehicle seat belt and possibly to get a better fit. Page 64 6-D Unsafe Vehicle Seats Never install this car seat in side-facing or rear-facing vehicle seats. To do this, you will need to change the seat belt to a locked mode for use with car seats. It is often hidden inside the panels on the walls of the vehicle or in the vehicle seat back.
Page 67 Note: Most vehicles manufactured after will have Switchable retractors in the back seat. When installing the car seat, route the vehicle seat belt through the proper belt path and buckle it in.
When installing the car seat, route the vehicle seat belt through the proper belt path and Page 70 Sliding Latch Plate and ALR Retractor A latch plate that slides freely on the belt webbing and cannot, by itself, hold the belt snug around a car seat.
Slowly pull the shoulder belt all the way out. Route the vehicle seat belt through the proper belt path and buckle it in. Page 71 Sliding Latch Plate and ELR Retractor A latch plate that slides freely on the belt webbing and cannot, by itself, hold the belt snug around a car seat.
With this retractor, you will need to use the locking clip to lock the vehicle seat belt. Call us at to order a locking clip. Locking Latch Plate and No Retractor When installing the car seat, route the lap seat belt through the proper path and buckle it in. Then, pull upwards on Grab the sides of the seat at the belt the tail of the belt so that Page 74 Headrest Pillow To remove, undo the fastening strip and pull the strap out of the harness slots.
To attach, thread the strap through the seat pad and car seat shell harness strap slots and attach the fastening strip. DO NOT thread the headrest pillow and harness straps through the same Page 75 8-A Cleaning Seat Pad 1. Remove Canopy Undo the snaps on the sides of the canopy from the seat pad. Push the release button on the canopy arm while pulling on the canopy to remove. Repeat on the other side. Page 76 3. Remove Harness Straps from Splitter Plate 4. Page 77 5. Pull Pad Off Shell Machine wash pad and canopy in cold water with gentle soap on delicate cycle and drip-dry.
Reverse the steps to reattach the pad to the shell. Make sure harness straps are not twisted. From the front, pull buckle out of the pad and shell. To clean, place in a cup of warm water and gently agitate the buckle. Page 79 Shake out excess water and allow to air dry. Repeat steps as needed until it fastens with a click. Re-insert the buckle into the same slot it was removed.
Pull up on crotch buckle to make sure it is secured. Inspect and clean buckle from time to time to remove any This lightweight stroller not only features a new one-second fold, it also has a multi-position reclining stroller seat that lies flat, and an extra-large storage basket. Designed with front swivel wheels with suspension, a multi-position reclining seat, and convertible safety harness, the FastAction Fold Stroller is well suited to busy schedules.
SnugRide 30 infant car seat is for infants 5 to 30 pounds rear facing and up to 30 inches. View larger. The stroller's lightweight design makes it portable and well suited to families with active schedules.
The FastAction Stroller's seat holds up to 50 pounds, making it a complete travel system for your growing child.
The SnugRide 30 complies with all US Safety standards and has been side impact tested for occupant retention by the harness system. Featuring EPS energy-absorbing foam liner, removable infant head support, and a five-point adjustable harness, the car seat provides a snug ride both in the car and on the stroller. For convenience, the durable car seat base can remain in your vehicle even when not using the car seat.
0コメント