Disk may fail soon windows cannot installed disk

When it's almost done installing it gives me an error. Is there any way to bypass this? Or should I try formatting the recovery partition and installing it there? Showing 1 - 13 of 13 comments. Sapph View Profile View Posts. Revelene View Profile View Posts. Sounds like you have a drive that already has an OS and has been partitioned already. To be able to install Windows, delete the partitions. The install will create new partitions as part of the install process. Remember, back up your data, if you have anything you want to keep on that drive.

Last edited by Revelene ; 1 Nov, pm. Originally posted by Revelene :. Details required : characters remaining Cancel Submit 26 people found this reply helpful. Was this reply helpful? Yes No. Sorry this didn't help. Thanks for your feedback.

I have the same question Report abuse. Details required :. Cancel Submit. Here are detailed steps:. Step 1: run Partition Wizard and choose the function for dynamic disk conversion. Right click on the dynamic disk you want to convert and choose " Convert Dynamic Disk to Basic Disk ". You can have a preview that this dynamic disk will become a basic disk without data loss.

At this time, press " Apply " to finish this conversion. Free Download Buy Now. Go to Disk Management and then delete all the volumes that were introduced one by one, which has been introduced in Error 1. After these steps, the dynamic disk will become basic automatically. Step 3: After all volumes on the dynamic disk are deleted, type " convert basic ". Once Diskpart shows it has successfully converted the selected dynamic disk to basic, you can type " exit " to quit from Diskpart. Nevertheless, if you do not want to delete any volume because of important data, there is a lossless solution below.

This computer's hardware may not support booting to this disk. Ensure the disk's controller is enabled in the computer's BIOS menu. For the first situation, please read the specification or contact a sales person to confirm whether there is hard disk protection if the computer is not configured by ourselves. If there is, remove the protection by following the instructions. However, when this solution does not work, you must change the hard disk mode manually in BIOS.

Actually, if Compatibility or Compatible is given, you must choose this mode. RAW disks cannot be detected as System or Boot, leading to offline and read only attributes. As a result, you cannot install Windows to these kinds of disks. For detailed steps, please see the corresponding Setup Reports Error of Microsoft. The disk may fail soon. If other hard disks are available, install Windows to another location.

At this time, you must stop Windows installation, and then backup important data immediately in case of a real disk failure. If there is not so much data that is required to back up, just copy and paste them to a safe place. However, if you want to backup all or a large number of data on the disk, using a third party disk clone software to back up the entire hard disk can save you a lot of time.